User manual
IP-CAMERA User Manual - 7
C
C
C
h
h
h
a
a
a
p
p
p
t
t
t
e
e
e
r
r
r
3
3
3
I
I
I
E
E
E
C
C
C
o
o
o
n
n
n
n
n
n
e
e
e
c
c
c
t
t
t
i
i
i
o
o
o
n
n
n
Input User name and password and then click “OK” button to login.
Note: User also can use the modified IP address of the IP-Cam. Input the IP address in the IE
browser bar and then click “Enter” to access IP-Cam. The default user name is admin. The
default password is 123456.
3.1.2Directly access through IE
The network service is default as shown below:
IP address: 192.168.226.201
Subnet Mask: 255.255.255.0
Gateway: 192.168.226.1
HTTP: 80
Data port: 9008
The first you used the device, you should connect the device with the above default settings.
Step 1: Manual setup the IP address of the PC, the network segment should be as same as the
default settings of IP-CAM. Right click “My Network Places” icon on the desktopselect
“Properties” as shown in the following left figure. Right click “Local Area Connection” at the
popup window, and then select “Property” as shown in the following right figure.
Select “Internet Protocol (TCP/IP)” in the “General” tabsclick “Properties”Manual input
network address information of the PC in the pop up window. Refer to the following figure: