User manual

IP-CAMERA User Manual - 46
C
C
C
h
h
h
a
a
a
p
p
p
t
t
t
e
e
e
r
r
r
8
8
8
Q
Q
Q
&
&
&
A
A
A
8Q & A
1. Q: How to find my password if I forget it?
A：Use the IP-Tool. Run the IP-Tool and right click the camera information to choose “Set
Factory Attribute”.
Default IP: 192.168.226.201.
User name: admin
Password: 123456
2. Q：Fail to connect devices through IE browser, why?
A: Network doesn’t connect well. Please check the connection and make sure it connected
well.
B: IP is not available. Reset the valid IP.
C: Web port number has been revised: contact administrator to get the correct port number.
D: Exclude the above reasons. Recover default setting by jointing the default line and GND
line.
Note: default IP: 192.168.226.201，mask number: 255.255.255.0
3. Q：IP tool cannot search devices, why?
A：It may be caused by the anti-virus software in your computer. Please exit it and try to
search device again.
4. Q：IE cannot download ActiveX control. How can I do?
a. IE browser blocks ActiveX. Please do setup following below.
① Open IE browser. Click Tools-----Internet Options….
② select Security------Custom Level….Refer to Fig 4-1
③ Enable all the sub options under “ActiveX controls and plug-ins”. Refer to Fig 4-2