User manual

Operation processes with remote controller to control multi-NVR
The default device ID of the NVR is 0. It’s not necessary to reset the device ID when a remote
is to be used to control a single NVR. However when controlling multiple NVRs with multiple
remote controllers, you would need to configure the device ID, please refer to below steps:
Activate remote controller to control the NVR: Turn the IR sensor of the remote controller
towards the IR receiver on the front panel, press the number key 8 twice on the remote, then
input device ID of the NVR to be controlled (Range from: 0-65535; the default device ID is 0)
press ENTER to confirm.
You can check the device ID of a NVR from System SetupBasicDevice ID. You can also
set multiple NVRs with the same device ID however this can cause interference if the NVRs
are kept close to each other.
Key points to check in case the remote doesn’t work.
1. Check batteries polarity and the remaining charge in the batteries.
2. Check IR controller sensor for any masking.
3. Check the ID of the remote with respect to the NVR.
If it still doesn't work, please try using a good known remote, or contact your dealer.