User manual
Upgrade Steps:
Step 1: Copy the upgrade software which gets from vendor into the USB storage device.
Step 2: Connect the USB flash drive to the USB port.
Step 3: Enter MenuUpgrade tab. Then the upgrade software name would be displayed in the
upgrade list box.
Step 4: Select that software and then click upgrade button. It will upgrade automatically.
Note: Please wait for a while when the system reboots. Never cut off power during upgrading. The original
configuration will be reserved after upgrade.
7.5 Logoff
Enter Main Menu Logoff tab. A log off dialogue box will pop up. The device will log off
by clicking “OK” button. If you want to log in again, click Main Menu icon to enter into user
name and password to re-login.
8 Remote Surveillance
8.1 IE Remote Surveillance
In order to view the NVR from a network it must be connected to a LAN/WAN or internet. The
network setup should be done accordingly. Please refer to 5.6 Network Setup. This NVR
supports IE browser, on Windows XP and Vista platform.
8.1.1 On LAN
Step 1: Enter into the NVR’s Main MenuSetupNetwork tab to input IP address, Subnet
Mask, etc. If using DHCP, please enable DHCP in both the NVR and the router.
Step 2: Enter Record Setup to set network video parameters like resolution, frame rate etc.
Step 3: Open IE on a computer on the same network. Input the IP address of the NVR in IE
address bar and press enter.
Step 4: IE will download ActiveX component automatically. Enter the username and password
in the subsequent window.
Notice: If HTTP port is not 80, other number instead, need add the port number after IP address. For
example, set HTTP port as 82, need input IP address like 192.168.0.25:82.
User name and password here are the same with that used on the NVR. The default is admin