User manual

Step 1: Enter into MenuSetupSchedule Motion tab.
Step 2: The setup steps for schedule for motion based recording are similar to normal schedule
setup. You can refer to 5.4.1 Schedule for details.
Note: The default schedule of motion based recording is 24 ⅹ 7. If you want to activate
motion based recording, you must enable motion alarm and setup schedule for motion
alarm (see Chapter 5.5.2 Motion Alarm for more details).
5.4.3 Sensor Schedule
This tab allows to set schedule for sensor based recording. The setting steps are as follows:
Step 1: Enter into MenuSetupScheduleSensor interface.
Step 2: The setup steps for schedule for sensor based recording are similar to normal schedule
setup (see Chapter 5.4.1 Schedule for details).
Note: The default schedule of sensor based recording is 24 ⅹ 7. If you want to activate
sensor based recording, you must enable sensor alarm and setup schedule for sensor
alarm (see Chapter 5.5.1 Sensor Alarm for more details).
5.5 Alarm Configuration
Alarm configuration includes four sub menus: sensor, motion, other alarm and alarm out.
5.5.1 Sensor Alarm
Sensor includes three sub menus: basic, alarm handling and schedule.
Operate the following steps to configure sensor alarm:
Step 1: Enter into MenuSetupAlarm SensorBasic tab. Refer to Fig 5-16:
Fig 5-16 Alarm Configuration-Sensor-Sensor
Step 2: Enable channels by checking the checkboxes beside the desired channels.
Step 3: Set the alarm type according to triggered alarm type. Two option: NO and NC.
Step 4: Click “Apply” button to save the setting.