Operation Manual

Step 2: Enable channels by checking the checkboxes beside the desired channels.
Step 3: Set the alarm type according to triggered alarm type. Two option: NO and NC.
Step 4: Click “Apply” button to save the setting.
Step 5: Enter into Alarm Handling tab. Refer to Fig 5-17. Select hold time and then click “Setting” button to
pop up a dialog box as shown in Fig 5-18.
Fig 5-17 Alarm Configuration-Sensor-Alarm Handling
Step 6: Enter into alarm tab to select the options to handle alarm.
Fig 5-18 Alarm Handling-Trigger
Buzzer: If selected, the local buzzer would be activated on an alarm.
Show Full Screen: If selected, there will pop up the chosen channel on the monitor on an alarm trigger.
To Alarm Out: If selected, this would trigger external relay output on an alarm.
Email: If selected, the NVR will send an email alert to the preconfigured email address in case of a sensor
based alarm from the particular input.
Snap: If selected, the system will snap images of the checked channels on an alarm and save them in the
HDD automatically.
Step 7: Enter into To Record tab. Select recording channels. It would be recorded in case of an alarm. Click
OK button to save the setting.