Operation Manual

Step 5: In the Area interface, you can drag slide bar to set the sensitivity value (1-8). The higher the value is
the more sensitive it is to motion. Since the sensitivity is influenced by color and time (day or night), you
can adjust its value according to the practical conditions. Left click the grid and drag to delete area. Click
icon to set the whole area as detection area. Click icon to clear the set detection area. Click
icon to test the sensitivity as per the local conditions. Once motion is sensed, it displays a figure icon.
Click icon, to save the setting. Click icon to exit the current interface.
Note: Prior to setting motion detection field it is recommended that you click icon to clear
the existing field and set afresh.
Step 6: Select “All” to set the same settings for all channels.
Step 7: Click “Apply” button to save the setting.
Step 8: Enter into Schedule tab. The setting steps for schedule for motion based alarm are similar to
normal schedule setup (see Chapter 5.4.1 for more details).
5.5.3 Other Alarm
This tab gives a choice to configure alarm for Disk Full, IP Conflict, the Disconnect event, etc.
Step 1: Enter into Menu  Setup Other Alarm. Refer to Fig 5-21:
Fig 5-21 Other Alarm
Step 2: Use the dropdown menu and select the event or the alarm.
Step 3: Check the required trigger options.
If the selected event is “Disk Full”, then use the drop down box for “Disk Shortage Alarm” to choose a
threshold value for remaining HDD space. If the threshold value is reached, the system will trigger the Disk
Full Alarm.
Step 4: Click “Apply” to save the setting.
5.5.4 Alarm Out
Alarm out includes three sub menus: alarm out, schedule and buzzer.
To set up alarm out: