User manual

AHD DVR User Manual

5.4.2MotionSchedule

Thistaballowstosetscheduleformotionbasedrecording.Thesettingstepsareasfollows:

① GotoMainMenuSetupScheduleMotiontab.

② Thesetupstepsforscheduleformotionbasedrecordingaresimilartonormalschedule

setup.Youcanreferto4.4.1Schedulefordetails.



Note:Thedefaultscheduleofmotionbasedrecordingis24

ⅹ

7.Ifyouwanttoactivate

motionbasedrecording,youmustenablemotionalarmandsetupscheduleformotion

alarm(seeChapter4.5.1MotionAlarmformoredetails).



5.5 AlarmConfiguration

Alarmconfigurationincludesfoursubmenus:motion,videoloss,otheralarmandalarmout.



5.5.1MotionAlarm

Motionincludestwosubmenus:motionandschedule.Thestepstosetmotionalarmareas

follows:

① GotoMainMenuSetupAlarmMotion.RefertoFig4‐17.



Fig4‐17AlarmCon figuration‐Motion



② Enablemotionalarm,setalarmholdtimewhichreferstothetimetillwhichthesystem

willwaitforfurtherdetectionofmotion.e.g.Iftheholdingtimeissetto10seconds,once

thesystemdetectsamotion, itwillgotoalarmbutwouldnotdetectany

othermotion

alarm(specifictochannel)until10seconds.Ifthereisothermotiondetectedduringthis

perioditisconsidereditascontinuousmovement,otherwiseitwillbeconsideredasa

singlemotion.

③ Click“Setting”buttonundertheTriggerarea.Thenawindowwillpopupasbelow:

