User manual

AHD DVR User Manual



③ EnabletheautoreportintheECMS/NVMSwhenaddinganewdevice.Theninputthe

remaininginformationofthedeviceintheECMS/NVMSandself‐defineadeviceID.

④ Inputtheabove‐mentionedserverIP,ser verportanddeviceIDintheserverinterface.

Then click “Apply ” button to

 save the setting. Now, the ECMS/NVMS system will

automaticallyconnectthisdevice.

5.6.5NAT

① GotoMainMenuSetupNetworkNATinterface.RefertoFig4‐27.



Fig4‐27NetworkConfigura tion‐NAT



② EnableNATandinputtheNATServer(ThedefaultNATServeriswww.provisionisr‐nat.com

andthedefaultportis8989

).

③ Click“Apply”tosavethesettings.

5.6.6OtherSet tings

IfyourDVRissettousePPPoEasitsdefaultnetworkconnection,youmaysetupDDNStobe

usedinconnection.Thesettingstepsareasfollows:

① EnableandselectDDNSserver.

② Enterusername,passwordandhostdomainnameoftheregisteredwebsite.

③ Click“Test”buttontotesttheeffectivenessoftherelevantinformation.

④ Click“Apply”buttontosavethesetting.

