Operation Manual

DVR User Manual
23
5.4.2 Motion Schedule
This tab allows to set schedule for motion based recording. The setting steps are as follows:
① Go to Main MenuSetupScheduleMotion tab.
② The setup steps for schedule for motion based recording are similar to normal schedule
setup. You can refer to 4.4.1 Schedule for details.
Note: The default schedule of motion based recording is 24 ⅹ 7. If you want to activate
motion based recording, you must enable motion alarm and set up schedule for motion
alarm (see Chapter 4.5.1 Motion Alarm for more details).
5.5 Alarm Configuration
Alarm configuration includes four sub menus: motion, video loss, other alarm and alarm out.
5.5.1 Motion Alarm
Motion includes two sub menus: motion and schedule. The steps to set motion alarm are as
follows:
① Go to Main MenuSetupAlarmMotion. Refer to Fig 4-17.
Fig 4-17 Alarm Configuration-Motion
② Enable motion alarm, set alarm hold time which refers to the time till which the system
will wait for further detection of motion. e.g. If the holding time is set to 10 seconds, once
the system detects a motion, it will go to alarm but would not detect any other motion
alarm (specific to channel) until 10 seconds. If there is other motion detected during this
period it is considered it as continuous movement, otherwise it will be considered as a
single motion.
③ Click “Setting” button under the Trigger area. Then a window will pop up as below: