User's Guide

Error! AutoText entry not defined. Error! AutoText entry not defined. User Guide

1) Access Point: This mode allows wireless stations to access this device.

Figure 4-8 Wireless Settings in Access Point mode

¾ SSID (Set Service Identifier) - Identifies your wireless network name. Create a name up to 32

characters and make sure all wireless points in the wireless network with the same SSID. The

default SSID is PROWARE_XXXXXX (XXXXXX indicates the last unique six characters of

each device’s MAC address). This value is case-sensitive. For example, TEST is NOT the

same as test.

¾ Channel - Determines the operating frequency to be used. It is not necessary to change the

wireless channel unless you notice interference problems with another nearby access point.

¾ Mode - Select the desired wireless mode. The options are:

• 11b only - Only 802.11b wireless stations can connect to the device.

• 11g only - Only 802.11g wireless stations can connect to the device.

• 11n only - Only 802.11n wireless stations can connect to the device.

• 11bg mixed - Both 802.11b and 802.11g wireless stations can connect to the device.

• 11bgn mixed - All 802.11b, 802.11g and 802.11n wireless stations can connect to the

device.

¾ Channel Width - Determines the channel width to be used. It is unnecessary to change the

default value unless required.

¾ Max Tx Rate - Specifies the maximum transmit rate of the device through this field.

¾ Enable Wireless Radio - Select or deselect this check box to allow or deny wireless stations

to access the device.