User's Guide

Error! AutoText entry not defined. Error! AutoText entry not defined. User Guide
28
6) Bridge with AP: This mode can bridge the AP and up to 4 APs also in bridge mode to
connect two or more wired LANs.
Figure 4-13 Wireless Settings in Repeater mode
¾ SSID (Set Service Identifier) - Identifies your wireless network name. Create a name up to 32
characters and make sure all wireless points in the wireless network with the same SSID. The
default SSID is PROWARE_XXXXXX (XXXXXX indicates the last unique six characters of
each device’s MAC address). This value is case-sensitive. For example, TEST is NOT the
same as test.
¾ Channel - Determines the operating frequency to be used. It is not necessary to change the
wireless channel unless you notice interference problems with another nearby access point.
¾ Mode - This field determines the wireless mode which the device works on.
11b only - Only 802.11b wireless stations can connect to the device.
11g only - Only 802.11g wireless stations can connect to the device.
11n only - Only 802.11n wireless stations can connect to the device.
11bg mixed - Both 802.11b and 802.11g wireless stations can connect to the device.
11bgn mixed - All 802.11b, 802.11g and 802.11n wireless stations can connect to the
device.