Instructions / Assembly

ALUMINUM BALUSTER INSTALLATION INSTRUCTIONS
Step 1: Stair rails and balusters can present an installation
challenge. Stair baluster connectors create a snug and accurate
baluster fit for stair angles ranging from 30 to 35 degrees (fig.1). Cut
top and bottom stair rails at the proper angle. Lay top and bottom
2x4 rails alongside the posts and mark.
Step 2: Clamp the top and bottom rails together with the top
2x4 rail inverted. Position rails as shown and mark 5-1/2"
on-center, working from the center out to the ends of the rails
(fig 2).
Step 3: Properly position the connectors on the rails. The top
and bottom connectors will be facing opposite directions (fig. 3).
Screw the connectors in place. To properly set connectors, begin
screwing vertically until the screw bites into the wood (fig. 4).
Reposition screw to the proper angle and tighten. Do not over-
tighten, which can move the connector off center.
Step 4: Make sure connectors are properly aligned, apply silicone
caulk to each connector and assemble the top and bottom rails
with the balusters (fig. 5). Then attach full rail section between the
stair rail posts (fig. 6).
©2015 Universal Forest Products, Inc. All rights reserved.
US Route 202, Greene, ME 04236 8397_7/15
www.ufpi.com
Stair Railing
THE DIAGRAMS AND INSTRUCTIONS IN THIS BROCHURE ARE FOR ILLUSTRATION PURPOSES ONLY AND ARE NOT MEANT TO REPLACE A LICENSED PROFESSIONAL. ANY CONSTRUCTION OR
USE OF THE PRODUCT MUST BE IN ACCORDANCE WITH ALL LOCAL ZONING AND/OR BUILDING CODES. THE CONSUMER ASSUMES ALL RISKS AND LIABILITY ASSOCIATED WITH THE
CONSTRUCTION OR USE OF THIS PRODUCT. THE CONSUMER OR CONTRACTOR SHOULD TAKE ALL NECESSARY STEPS TO ENSURE THE SAFETY OF EVERYONE INVOLVED IN THE PROJECT,
INCLUDING, BUT NOT LIMITED TO, WEARING THE APPROPRIATE SAFETY EQUIPMENT. UNIVERSAL FOREST PRODUCTS, INC., MAKES NO WARRANTY, EITHER EXPRESS OR IMPLIED,
AND SHALL NOT BE LIABLE FOR ANY DAMAGES, INCLUDING CONSEQUENTIAL DAMAGES.
fig. 1
fig. 2 fig. 3
fig. 4 fig. 5
fig. 6