User's Manual

Caution!

The sealing nut (A) must not be tightened until the sealing cap (C)

over the RJ45 connector has been tightened to the unit during nal

installation; otherwise, the Ethernet cable may twist and become

damaged.

Notes:

The cable must feed through all parts of the weatherproof cap before the

RJ45 is crimped on the outdoor Ethernet a cable.

The cable between the power injector and the unit must be a straight-

through Ethernet cable (without crossover).

Due to variance in CAT5 cable diameter, termination techniques of the

installer, and the application of proper tightness of the connectors, it

is strongly recommended that the CAT5 cable connector and the serial

connector cap are further secured by external weatherproong (in addition

to the antenna N connector, where applicable). Butyl weatherproong tape

is the preferred material for securing any external connector.

Attach the mounting plate (A) using the provided screws and washers

(Torque 9 N∙m/75 in-lbs), such that the unit’s antenna will be vertically or

horizontally polarized when mounted.

Attach the extension arm (B) to mounting piece (A) with the screw, nut,

and washers provided, as shown below. The extension arm gives the unit

more possible tilt, letting you adjust for azimuth or elevation over a larger

angle.

▪