User's Manual

Step 3: Connect the Cables

If you have not already done so, connect the normal RJ45 connector on an

outdoor-rated CAT5 cable to the “Data and Power Out” port on the power

injector.

Note:

On R1 versions, connect the cable to the port labeled “J1 Antenna” on the

power injector (not pictured). This port has 48 VDC power on the RJ45.

Attach the other end of the CAT5 cable with RJ45 connector to the Power

and Ethernet port on the back of the unit (see the following gure). Note

that the rst attachment of this cable is meant to verify operation and

congure the unit; the nal attachment (with proper torque values) and

weatherproong are to be done after the unit has been installed in the

location at which it will operate (See Step 7: Complete Installation).

Caution!

Do not over-tighten the connector nuts; do not use a wrench to

tighten the connectors!