User's Manual

To connect the unit through a hub or a switch to a PC, use a straight-

through Ethernet cable between the network interface card in the PC and

the hub, and between the hub and the RJ45 “Data In” port on the PoE

adapter.

Note:

On R1 units, connect the cable between the hub and the RJ45 “J2 PC/

Router” port on the power injector (not pictured).

If you are connecting the PC directly to the unit, use a crossover Ethernet

cable between the network interface card in the PC and the RJ45 “Data In”

port on the power injector.

Note:

On R1 units, connect the cross-over cable between the network interface

card in the PC and the and the RJ45 “J2 PC/Router” port on the power

injector (not pictured).