User's Manual

Step 5: View LEDs

On most units, the LEDs are present at the unit’s Ethernet connector; unscrew

the watertight cap if necessary to view the LEDs.

NOTE:

Make sure the domed sealing nut is loose before unscrewing the cap or the

Ethernet cable may be twisted and damaged.

When the unit is powered on, it performs startup diagnostics. When startup is

complete, the LEDs show the unit’s operational state, as follows:

LED State Power/Ethernet LED Radio LED

Blinking Green Power is on, unit is booting up,

Ethernet link is down.

Radios are being initialized.

Steady Green Power is on, Ethernet link is up. Radios are being operational.

Note:

On R1 units, there is one LED. It is the power LED that appears in the back

of the unit, between the cooling ns on the right side. (See Figure 2.)

On power-up, the LED ashes red during initial start-up, and then turns

solid red while booting. After a successful boot, it becomes solid green to

indicate normal operation.

Caution!

Before applying power to the units, make sure that a proper load or

antenna is connected to each N-female jack to minimize the chance

of damaging the RF power ampliers.