User's Manual
All rights reserved Page 17
Step 6: Mount the Unit
Caution:
To ensure that water does not gather around the antenna
connectors, mount the unit with the antenna connectors facing
downward.
To pole-mount, insert screws through bracket F and fasten around pole to
bracket E and secure (Torque 11 N
.
m/100 in-lbs).
To wall-mount the unit, mount bracket (E) to wall using 4 screws (not
provided), as shown:
Note:
At the end of the installation, the Ethernet and serial ports must be made
waterproof by installing the caps. Be careful not to over-tighten the caps as
damage to the cable may occur.
1.
2.
IMPORTANT!
If the AP is going to be used as part of a Mesh network, you will need to
perform initial conguration of the parameters mentioned in the Prereq-
uisites section of this AP-4000MR-LR User Guide before you mount the
AP. See the User Guide for more information on conguring these param-
eters.
IMPORTANT!
If the AP is going to be used as part of a Mesh network, you will need to
perform initial conguration of the parameters mentioned in the Prereq-
uisites section of this AP-4000MR-LR User Guide before you mount the
AP. See the User Guide for more information on conguring these param-
eters.