User's Manual

Note:

If your Access Point does not appear in the Scan List, click the Rescan

button to update the display. If the unit still does not appear in the list, see

the Troubleshooting chapter in the AP-4000MR-LR User Guide for suggestions.

Note that after rebooting an Access Point, it may take up to ve minutes for

the unit to appear in the Scan List.

Do one of the following:

If the AP has been assigned an IP address by a DHCP server on the

network, write down the IP address and click Cancel to close ScanTool.

Proceed to the Logging In section below for information on how to access

the HTTP interface using this IP address.

Note:

Mesh APs must be congured with static IP addresses. To assign the AP a

static IP address, follow the steps below.

If the AP has not been assigned an IP address (in other words, the unit

is using its default IP address, 169.254.128.132), follow these steps to

assign it a static IP address that is valid on your network:

Highlight the entry for the AP you want to congure.

Click the Change button. The Change screen appears.

Set IP Address Type to Static.

▪