User's Manual

Enter the HTTP password in the Password eld. Leave the User Name

eld blank. For new units, the default HTTP password is public.

If you are logging on for the rst time the Setup Wizard will launch

automatically.

Note

Setup Wizard will not relaunch on subsequent logins. To force the Setup

Wizard to launch upon login, click htManagement > Services and choose

Enable from the Setup Wizard drop down menu.

To congure the AP using the Setup Wizard, see Using the Setup

Wizard, below. To congure the AP without using the Setup Wizard,

click Exit. Upon clicking Exit, the System Status screen will appear. See

the “Advanced Conguration” chapter in the AP-4000MR-LR User Guide for

conguration instructions.

Using the Setup Wizard

The Setup Wizard provides step-by-step instructions for how to congure

the Access Point’s basic operating parameters, such as Network Name, IP

parameters, system parameters, and management passwords.

Click Setup Wizard to begin. The Setup Wizard supports the following

navigation options:

Save & Next Button: Each Setup Wizard screen has a Save & Next

button. Click this button to submit any changes you made to the unit’s

parameters and continue to the next page. The instructions below

describe how to navigate the Setup Wizard using the Save & Next

buttons.

Navigation Panel: The Setup Wizard provides a navigation panel

on the left-hand side of the screen. Click the link that corresponds to

the parameters you want to congure to be taken to that particular

▪