User's Manual

INTRODUCTION

The AP-4000MR-LR is a ruggedized tri-mode AP optimized for outdoor

deployments. It is equipped with one embedded 802.11a radio and one

embedded 802.11b/g radio, enabling simultaneous support of 802.11a,

802.11b, and 802.11g clients as well as Mesh operation on either the 2.4 or 5.8

GHz band.

There are two versions of the AP-4000MR-LR hardware. Differences between

hardware versions are highlighted in this manual as necessary. See Figure 1

and Figure 2.

You can verify which hardware version you are using through either the HTTP

Interface or CLI Interface. See the AP-4000MR-LR User Guide for information on

locating your hardware version number.

AP-4000MR-LR units can operate either using PoE with the combination DC

power supply/injector provided or directly from a 100 - 240 VAC power source

(AC cable ordered separately).

The units feature internal lightning and surge protection on the AC and DC

power ports, the Ethernet port, and on both antenna ports. External antenna

lightning protection is not needed.

Note:

On R1 versions, internal lightning and surge protection is not available on

the Ethernet port.

Each unit is equipped with:

Power/Ethernet port: used for Ethernet connection and Power over

Ethernet (PoE) using the supplied power injector.

Serial connection: used for entering commands in the Command Line

Interface (CLI). R1 versions of the product are not equipped with a serial

connection.

LED indicator(s): dual LEDs used to indicate the power and operational

states of the unit. R1 versions of the product are equipped with a single

power LED.

AC power input: enables direct power from external AC power source.

External antenna connectors (two): one for 2.4 GHz operation, the

other for 5.8 GHz operation.

Grounding screws (two)

▪