User's Manual

Page 8 Copyright © 2006 Proxim Wireless
HARDWARE AND SOFTWARE INSTALLATION
Notes:
Be sure to read the Release Notes le on the product CD as it contains
software version and driver information that may not have been available
when this document was produced.
Equipment is to be used with, and powered by, the power injector provided
or by a power injector that meets these requirements:
UL-Listed/ITE (NWGQ)
Limited Power Source Output per UL/IEC 60950
CE-marked
Approved for Power-over-Ethernet
Rated output, 48 Vdc/0.42 A
Pinout follows 802.3af standard for mid-span devices
▪
▪
–
–
–
–
–
–
IMPORTANT!
Before installing this product, see Safety and Regulatory Compliance
Information on the product CD for important information.
IMPORTANT!
Before installing this product, see Safety and Regulatory Compliance
Information on the product CD for important information.
IMPORTANT!
All AP-4000MR-LR units must be installed by a suitably trained profession-
al installation technician or by a qualied installation service.
IMPORTANT!
All AP-4000MR-LR units must be installed by a suitably trained profession-
al installation technician or by a qualied installation service.
WARNING!
To ensure proper grounding, use the hole at the bottom point on the back
of each unit and the provided grounding screws to attach a ground wire of
at least 10 AWG stranded to each unit. This wire must be as short as pos-
sible and must be connected to a low-impedance earth ground. Use proper
wire grounding techniques in accordance with local electric codes.
WARNING!
To ensure proper grounding, use the hole at the bottom point on the back
of each unit and the provided grounding screws to attach a ground wire of
at least 10 AWG stranded to each unit. This wire must be as short as pos-
sible and must be connected to a low-impedance earth ground. Use proper
wire grounding techniques in accordance with local electric codes.