User's Manual
Table Of Contents
- Monitoring
- Commands
- Procedures
- Troubleshooting
- Frequency Bands and Channels
- Technical Specifications
- Part Numbers
- Regulatory Approvals and Frequency Ranges
- Integrated Antenna Specifications
- RF Modulation and Over-the-Air Rates
- Wireless Protocol
- Device Interface
- Network Architecture Type
- Receive Sensitivity
- Maximum Throughput
- Latency
- Transmit Power Settings
- Range Information
- System Processor and Memory
- Software Specification
- Security
- Management
- Antenna
- Status LEDs
- Local Configuration Support
- Compliance and Standards
- Electrical
- Dimensions
- Subscriber Unit with Integrated 21-dBi Antenna Unpackaged: 12.60 in x 12.60 in x 3.50 in (320 mm x 320 mm x 18 mm) Weight
- Environmental
- Packaging Contents
- MTBF
- Warranty
- Lightning Protection
- Technical Services and Support
- Statement of Warranty
Configuration MP.11 4954-R Installation and Management
QoS (Quality of Service) Parameters
108
To add entries to the PIR Table, click the Add Table Entries button. Enter the Rule Name and select Enable or Disable
from the Entry Status drop-down box, then click Add to add the entry. Once the new entry appears on the screen (as
shown below), click its Details button to view/edit its parameters.
QoS SFC Configuration
Click Configure > QoS > QoS SF Class. The 7 predefined SFCs are shown.