User's Manual
Table Of Contents
- Monitoring
- Commands
- Procedures
- Troubleshooting
- Frequency Bands and Channels
- Technical Specifications
- Part Numbers
- Regulatory Approvals and Frequency Ranges
- Integrated Antenna Specifications
- RF Modulation and Over-the-Air Rates
- Wireless Protocol
- Device Interface
- Network Architecture Type
- Receive Sensitivity
- Maximum Throughput
- Latency
- Transmit Power Settings
- Range Information
- System Processor and Memory
- Software Specification
- Security
- Management
- Antenna
- Status LEDs
- Local Configuration Support
- Compliance and Standards
- Electrical
- Dimensions
- Subscriber Unit with Integrated 21-dBi Antenna Unpackaged: 12.60 in x 12.60 in x 3.50 in (320 mm x 320 mm x 18 mm) Weight
- Environmental
- Packaging Contents
- MTBF
- Warranty
- Lightning Protection
- Technical Services and Support
- Statement of Warranty
MP.11 4954-R Installation and Management
133
8
Commands
This chapter describes the commands that you can issue with the Web Interface.
Click the Commands button to access available commands. See the following:
• Download (see Download Files)
• Upload (see Upload Files)
• Downgrade (see Downgrade to Previous Release)
• Reboot (see Reboot the Unit)
• Reset (see Reset the Unit to Factory Default)
• Help Link (see Set the Help Link Location)
Help and Exit buttons also appear on each page of the Web interface; click the Help button to access online help; click
the Exit button to exit the application.
For an introduction to the basics of management, see Basic Management.
Download Files
Click Commands > Download tab to download configuration, image and license files to the unit via a TFTP server (see
TFTP Server Setup for information about the SolarWinds TFTP server software located on your product installation CD).
The following parameters may be configured or viewed:
• Server IP address: Enter the TFTP Server IP address.
• File Name: Enter the name of the file to be downloaded. If you are using the SolarWinds TFTP server software
located on your product installation CD, the default directory for downloading files is C:\TFTP-Root.
• File Type: Choose either Config, image, BspBl, or license.
• File Operation: Choose either Download or Download and Reboot.
Click OK to start the download.