User's Manual
Table Of Contents
- Monitoring
- Commands
- Procedures
- Troubleshooting
- Frequency Bands and Channels
- Technical Specifications
- Part Numbers
- Regulatory Approvals and Frequency Ranges
- Integrated Antenna Specifications
- RF Modulation and Over-the-Air Rates
- Wireless Protocol
- Device Interface
- Network Architecture Type
- Receive Sensitivity
- Maximum Throughput
- Latency
- Transmit Power Settings
- Range Information
- System Processor and Memory
- Software Specification
- Security
- Management
- Antenna
- Status LEDs
- Local Configuration Support
- Compliance and Standards
- Electrical
- Dimensions
- Subscriber Unit with Integrated 21-dBi Antenna Unpackaged: 12.60 in x 12.60 in x 3.50 in (320 mm x 320 mm x 18 mm) Weight
- Environmental
- Packaging Contents
- MTBF
- Warranty
- Lightning Protection
- Technical Services and Support
- Statement of Warranty
Configuration MP.11 4954-R Installation and Management
VLAN Parameters
104
Restricting Unit Management
Management access to the unit can be easily secured by making management stations or hosts and the unit itself
members of a common VLAN. Simply configure a non-zero management VLAN ID: management of the unit will be
restricted to members of the same VLAN.
CAUTION: If a non-zero management VLAN ID is configured, management access to the unit is restricted to hosts that
are members of the same VLAN. Ensure your management platform or host is a member of the same VLAN
before attempting to manage the unit or you will lose access to the unit.
Providing Access to Hosts in the Same VLAN
The VLAN feature lets hosts manage the unit. If the Management VLAN ID matches a VLAN User ID, those hosts who
are members of that VLAN will have management access to the unit.
CAUTION: Once a VLAN Management ID is configured and is equivalent to one of the VLAN User IDs, all members of
that VLAN will have management access to the unit. Be careful to restrict VLAN membership to those with
legitimate access to the unit.
SU VLAN Configuration
The HTTP Interface to configure SU VLAN parameters is shown in the following figure.
Add SU Table Entries
To add entries to the SU VLAN Table, click the Add Table Entries button. Enter the desired parameters in the
corresponding fields, then click Add to add and save the entry.