User's Manual
Table Of Contents
- Monitoring
- Commands
- Procedures
- Troubleshooting
- Frequency Bands and Channels
- Technical Specifications
- Part Numbers
- Regulatory Approvals and Frequency Ranges
- Integrated Antenna Specifications
- RF Modulation and Over-the-Air Rates
- Wireless Protocol
- Device Interface
- Network Architecture Type
- Receive Sensitivity
- Maximum Throughput
- Latency
- Transmit Power Settings
- Range Information
- System Processor and Memory
- Software Specification
- Security
- Management
- Antenna
- Status LEDs
- Local Configuration Support
- Compliance and Standards
- Electrical
- Dimensions
- Subscriber Unit with Integrated 21-dBi Antenna Unpackaged: 12.60 in x 12.60 in x 3.50 in (320 mm x 320 mm x 18 mm) Weight
- Environmental
- Packaging Contents
- MTBF
- Warranty
- Lightning Protection
- Technical Services and Support
- Statement of Warranty
Configuration MP.11 4954-R Installation and Management
QoS (Quality of Service) Parameters
107
QoS (Quality of Service) Parameters
The Quality of Service (QoS) feature is based on 802.16 standard and defines the classes, service flows (SFCs), and
packet identification rules (PIRs) for specific types of traffic. The main priority of QoS is to guarantee a reliable and
adequate transmission quality for all traffic types under conditions of high congestion and bandwidth over-subscription
(for a complete discussion on QoS see Quality of Service (QoS).
There are already several pre-defined QoS classes, SFCs and PIRs available that you may choose from which cover the
most common types of traffic. If you want to configure something else, you start building the hierarchy of a QoS class by
defining PIRs; then you associate some of those PIRs to specific Service Flow classes (SFCs); you assign priorities to
each PIR within each SFC; and finally you define the QoS class by associating relevant SFCs to each QoS class.
QoS PIR Configuration
Click Configure > QoS > QoS PIR Table. The 17 predefined PIRs are shown.
To view/edit the parameters of each PIR click on its Details button. You may enable, disable or delete any PIR entry by
clicking on the Status drop-down box and then clicking OK.