User's Manual

Installation and Initialization MP.11 4954-R Installation and Management

Hardware Installation

• The Antenna Alignment Display (AAD) CLI command is disabled automatically 30 minutes after it is enabled to

remove the load of extra messages on the wireless interface. The default telnet timeout is 900 seconds (15

minutes). If AAD must run for the entire 30 minutes, change the default telnet timeout value to a value greater

than 30 minutes (greater than 1800 seconds). This restriction is for telnet connections only and not for the serial

interface. The serial interface never times out; however, the AAD command does still time out.

Antenna Alignment Commands

• set aad enable local: Enables display of the local SNR. Local SNR is the SNR measured by the receiver at the

near end.

• set aad enable remote: Enables display of the remote SNR. Remote SNR is the SNR as measured by the

receiver at the far end.

• set aad enable average: Enables display of the average SNR. The average SNR is the average of the local and

remote SNR.

• set aad disable: Disables Antenna Alignment Display (Ctrl-C also disables AAD).