User's Manual

Configuration MP.11 4954-R Installation and Management
Network Parameters
64
Configure IP Routes (Routing Mode only)
Click Configure > Network > IP Routes to configure IP routes. You cannot configure IP Routes in Bridge mode. In
Routing mode, the Add Table Entries and Edit/Delete Table Entries buttons are enabled.
Click the Add button to add entries; a window such as the following is displayed:
Enter the route information and click Add. The IP Address and Subnet Mask combination is validated for a proper
combination.
NOTE: When adding a new entry, the IP address of the Route Destination must be in either the Ethernet subnet or in the
wireless subnet of the unit.
Click the Edit/Delete Table Entries button to make changes to or delete existing entries.