Manualshelf

User's Manual

ManualsBrandsProxim Wireless ManualsElectronicsSingle Band Wireless AP W/ Build in Amplifiers
71727374757677787980
Configuration MP.11 4954-R Installation and Management
Network Parameters
69
NOTE: There must be at least one entry in the DHCP server IP Pool Table to enable DHCP server. Also, DHCP
server cannot be enabled if DHCP Relay Agent is enabled.
• Subnet Mask: The unit supplies this subnet mask in its DHCP response to a DHCP request from an Ethernet host.
Indicates the IP subnet mask assigned to hosts on the Ethernet side using DHCP.
• Gateway IP Address: The unit supplies this gateway IP address in the DHCP response. Indicates the IP address of a
router assigned as the default gateway for hosts on the Ethernet side.
• Primary DNS IP Address: The unit supplies this primary DNS IP address in the DHCP response. Indicates the IP
address of the primary DNS server that hosts on the Ethernet side uses to resolve Internet host names to IP
addresses
• Secondary DNS IP Address: The unit supplies this secondary DNS IP address in the DHCP response.
• Number of IP Pool Table Entries: The number of IP pool table entries is a read-only field that indicates the total
number of entries in the DHCP server IP Pool Table. See Add Entries to the DHCP Server IP Pool Table.
Add Entries to the DHCP Server IP Pool Table
You can add up to 20 entries in the IP Pool Table. An IP address can be added if the entry’s network ID is the same as the
network ID of the device. To add an entry click Add Table Entries.
Enter the following parameters and click Add:
NOTE: After adding entries, you must reboot the unit before the values take effect.
• Start IP Address: Indicates the starting IP address that is used for assigning address to hosts on the Ethernet side in
the configured subnet.
• End IP Address: Indicates the ending IP address that is used for assigning address to hosts on the Ethernet side in
the configured subnet.
• Default Lease Time: Specifies the default lease time for IP addresses in the address pool. The value is 3600-86400
seconds.
• Max Lease Time: The maximum lease time for IP addresses in the address pool. The value is 3600-86400 seconds.
• Comment: The comment field is a descriptive field of up to 255 characters.
Edit/Delete Entries to the DHCP Server IP Pool Table Entries
Click Edit/Delete Table Entries to make changes; enter your changes and click OK.