User Manual

Certified Solutions
WARNING: In order to use external antennas, your accesspoint must be equipped with an external antenna connector.
This antenna connection cable enables you to connect your ORiNOCO AP-600 access point to an external antenna. The
cable has on one side a an Proxim propietary connector, the other side has an industry-standard
N-connector/reverse N-connector. The user must use the correct type of antennas, cables and surge arrestor. Local radio
regulations or legislation may impose restrictions on the use of specific combinations. The user of this cable has to verify
that by using this cable, the legal requirements that are appropriate for the equipment and/or installation are complied with.
Examples of this are country specific type-approvals and/or maximum radiated output power. The antenna installer must
be a professional, aware of these regulations. At all times, it will be the responsibility of the end user to ensure that an
antenna installation complies with local radio regulations. For additional regulatory information, consult the regulatory flyer
delivered with your ORiNOCO access point. Proxim and its resellers or distributors are not liable for any damage or
violation of government regulations that may arise from the use of this cable.
FCC regulated countries
Note 1). Accepting countries: USA, Canada, Mexico, Brazil, Australia, Taiwan and unregulated countries.
Note 2). When using the 24dBi Parabolic Antenna, channels 1, 2, 10 and 11 cannot be used.
Note 3). For the products listed above, the 2.4GHz channels 13 and 14 are inaccessible.
Note 4). Radio models B11FNF, G11FNF and C38WCW are limited for use in AP-600 only.
Note 5). It is strictly prohibited to operate C38WCW outdoors in the frequency range of 5.15 to 5.25 GHz.
ETSI regulated countries
Note 1). Accepting countries: Europe (EU Counties including Norway and Switzerland), Singapore, Hong Kong.
Note 2). It is not allowed to connect any external antenna in: China. Proxim does not support this.
ORiNOCO access point
antenna
connector cable
surge arrester
applicable antenna
extension cables
Certified ORiNOCO
antennas
AP-600 11b (radio:B11FNF)
applicable
1,2,3)
mandatory
for outdoor
applications
6 m (20ft) LMR-400
15m (50ft) LMR-400
22m (75ft) LMR-400
7dBi and 10dBi Omni
12dBi W-Angle / Window
14dBi Patch / Yagi
24dBi Parabolic Grid
2)
AP-600 11g (radio G11FNF)
not applicable - - not certified
AP-600 11abg
(radio:C38WCW)
applicable
1,3,4,5)
not applicable not applicable dual band range extener
(model: AIN-WB-OD-B)
mandatory
for outdoor
applications
6 m (20ft) LMR-400
15m (50ft) LMR-400
22m (75ft) LMR-400
7dBi and 10dBi Omni
12dBi W-Angle / Window
14dBi Patch / Yagi
ORiNOCO access point
antenna
connector cable
surge arrester
applicable antenna
extension cables
Certified ORiNOCO
antennas
AP-600 11b (radio:B13ENE)
AP-600 11g (radio:G13ENE)
applicable
1)
mandatory
for outdoor
applications
optional / any length 7dBi Omni
22m (75ft) LMR-400 10dBi Omni