User Manual
Table Of Contents
- Monitoring
- Commands
- Troubleshooting
- Command Line Interface (CLI)
- General Notes
- Command Line Interface (CLI) Variations
- CLI Command Types
- Using Tables and Strings
- Configuring the AP using CLI commands
- Log into the AP using HyperTerminal
- Log into the AP using Telnet
- Set Basic Configuration Parameters using CLI Commands
- Set System Name, Location and Contact Information
- Set Static IP Address for the AP
- Change Passwords
- Set Network Names for the Wireless Interface
- Enable 802.11d Support and Set the Country Code
- Enable and Configure TX Power Control for the Wireless Interface(s)
- Configure SSIDs (Network Names), VLANs, and Profiles
- Download an AP Configuration File from your TFTP Server
- Backup your AP Configuration File
- Set up Auto Configuration
- Other Network Settings
- Configure the AP as a DHCP Server
- Configure the DNS Client
- Configure DHCP Relay
- Configure DHCP Relay Servers
- Maintain Client Connections using Link Integrity
- Change Wireless Interface Settings
- Set Ethernet Speed and Transmission Mode
- Set Interface Management Services
- Configure Syslog
- Configure Intra BSS
- Configure Wireless Distribution System
- Configure MAC Access Control
- Set RADIUS Parameters
- Set Rogue Scan Parameters
- Set Hardware Configuration Reset Parameters
- Set VLAN/SSID Parameters
- Set Security Profile Parameters
- CLI Monitoring Parameters
- Parameter Tables
- CLI Batch File
- ASCII Character Chart
- Specifications
- Technical Services and Support
- Statement of Warranty
Monitoring AP-4000/4000M/4900M User Guide
Interfaces
145
Interfaces
This tab displays statistics for the Ethernet and wireless interfaces.
Figure 5-8 Interface Monitoring Tab (Ethernet)
Description of Interface Statistics
The following statistics are displayed for the Ethernet interface only, either of the wireless interfaces only, or for all
interfaces:
• Admin Status (Ethernet/Wireless-Slot A/B): The desired state of the interface: Up (ready to pass packets), Down (not
ready to pass packets, or Testing (testing and unable to pass packets).
• Alignment Error (Ethernet): The number of frames received that are not an integral number of octets in length and do
not pass the Frame Check Sequence check.
• Carrier Sense Errors (Ethernet): The number of times that the carrier sense condition was lost or never asserted
when attempting to transmit a frame. The count increments at most once per transmission attempt.
• Deferred Transmission (Ethernet): The number of frames for which the first transmission attempt is delayed because
the medium is busy.This number does not include frames involved in collisions.
• Description (Ethernet/Wireless-Slot A/B): Information about the interface (e.g., the name of the manufacturer, the
product name and the version of the hardware interface).
• Duplicate Frame Count (Wireless-Slot A/B): The number of duplicate frames received.