User Manual
Table Of Contents
- Monitoring
- Commands
- Troubleshooting
- Command Line Interface (CLI)
- General Notes
- Command Line Interface (CLI) Variations
- CLI Command Types
- Using Tables and Strings
- Configuring the AP using CLI commands
- Log into the AP using HyperTerminal
- Log into the AP using Telnet
- Set Basic Configuration Parameters using CLI Commands
- Set System Name, Location and Contact Information
- Set Static IP Address for the AP
- Change Passwords
- Set Network Names for the Wireless Interface
- Enable 802.11d Support and Set the Country Code
- Enable and Configure TX Power Control for the Wireless Interface(s)
- Configure SSIDs (Network Names), VLANs, and Profiles
- Download an AP Configuration File from your TFTP Server
- Backup your AP Configuration File
- Set up Auto Configuration
- Other Network Settings
- Configure the AP as a DHCP Server
- Configure the DNS Client
- Configure DHCP Relay
- Configure DHCP Relay Servers
- Maintain Client Connections using Link Integrity
- Change Wireless Interface Settings
- Set Ethernet Speed and Transmission Mode
- Set Interface Management Services
- Configure Syslog
- Configure Intra BSS
- Configure Wireless Distribution System
- Configure MAC Access Control
- Set RADIUS Parameters
- Set Rogue Scan Parameters
- Set Hardware Configuration Reset Parameters
- Set VLAN/SSID Parameters
- Set Security Profile Parameters
- CLI Monitoring Parameters
- Parameter Tables
- CLI Batch File
- ASCII Character Chart
- Specifications
- Technical Services and Support
- Statement of Warranty
Command Line Interface (CLI) AP-4000/4000M/4900M User Guide
Configuring the AP using CLI commands
196
Enable/Disable Closed System
[Device-Name]>set wif <index> closedsys <enable/disable>
Shutdown/Resume Wireless Service
[Device-Name]>set wif <index> wssstatus <1 (resume)/2 (shutdown)>
Set Load Balancing Maximum Number of Clients
[Device-Name]>set wif <index> lbmaxclients <1–63>
Set the Multicast Rate (802.11a or 4.9 GHz)
[Device-Name]>set wif 3 multrate <6, 12, 24
(Mbits/sec)>
Set the Multicast Rate (802.11b/g)
[Device-Name]>set wif 4 multrate <1, 2, 5.5, 11
(Mbits/sec)>
Enable/Disable Super Mode (802.11a/g only)
[Device-Name]>set wif <index> supermode <enable/disable>
Enable/Disable Turbo Mode (802.11a/g only)
[Device-Name]>set wif <index> turbo <enable/disable>
NOTE: Super mode must be enabled on the interface before Turbo mode can be enabled.
NOTE: Turbo mode and Mesh mode (either Mesh AP or Mesh Portal) can not be enabled on the same interface
simultaneously.
Configure Antenna Diversity
NOTE: When the AP-4900M is in 4.9 GHz Public Safety operational mode, antenna diversity is disabled by default, and
antenna 3 is configured for use.
[Device-Name]>set wif 3 atdiversity <3, 4, 5(auto)> (see below)
[Device-Name]>set wif 4 atdiversity <1, 2, 5(auto)> (see below)
[Device-Name]>reboot 0
NOTE: See Antennas for more information on internal and external antenna ports.
Value Corresponding Antenna Enabled
1 802.11b/g (connector 1)
2 802.11b/g (connector 2)
3 802.11a/4.9 GHz (connector 3)
4 802.11a/4.9 GHz (connector 4)
5 (auto) Both antennas on interface