User Manual
Table Of Contents
- Monitoring
- Commands
- Troubleshooting
- Command Line Interface (CLI)
- General Notes
- Command Line Interface (CLI) Variations
- CLI Command Types
- Using Tables and Strings
- Configuring the AP using CLI commands
- Log into the AP using HyperTerminal
- Log into the AP using Telnet
- Set Basic Configuration Parameters using CLI Commands
- Set System Name, Location and Contact Information
- Set Static IP Address for the AP
- Change Passwords
- Set Network Names for the Wireless Interface
- Enable 802.11d Support and Set the Country Code
- Enable and Configure TX Power Control for the Wireless Interface(s)
- Configure SSIDs (Network Names), VLANs, and Profiles
- Download an AP Configuration File from your TFTP Server
- Backup your AP Configuration File
- Set up Auto Configuration
- Other Network Settings
- Configure the AP as a DHCP Server
- Configure the DNS Client
- Configure DHCP Relay
- Configure DHCP Relay Servers
- Maintain Client Connections using Link Integrity
- Change Wireless Interface Settings
- Set Ethernet Speed and Transmission Mode
- Set Interface Management Services
- Configure Syslog
- Configure Intra BSS
- Configure Wireless Distribution System
- Configure MAC Access Control
- Set RADIUS Parameters
- Set Rogue Scan Parameters
- Set Hardware Configuration Reset Parameters
- Set VLAN/SSID Parameters
- Set Security Profile Parameters
- CLI Monitoring Parameters
- Parameter Tables
- CLI Batch File
- ASCII Character Chart
- Specifications
- Technical Services and Support
- Statement of Warranty
Command Line Interface (CLI) AP-4000/4000M/4900M User Guide
Parameter Tables
215
4.9 GHz Specific Parameters
802.11a Specific Parameters
Name Type Value Access CLI Parameter
Operating Frequency
Channel
Integer Varies by regulatory
domain and country. See
Available Channels
RW channel
Supported Data Rates Octet String See Transmit Rate,
below
R suppdatarates
Transmit Rate Integer32 10 MHz:
0 (Auto Fallback)
3 Mbits/s
4.5 Mbits/s
6 Mbits/s
9 Mbits/s
12 Mbits/s
18 Mbits/s
24 Mbits/s
27 Mbits/s.
20 MHz:
0 (Auto Fallback)
6 Mbits/sec
9 Mbits/sec
12 Mbits/sec
18 Mbits/sec
24 Mbits/sec
36 Mbits/sec
48 Mbits/sec
54 Mbits/sec
RW txrate
Physical Layer Type Integer ofdm (orthogonal
frequency division
multiplexing)
Rphytype
Super Mode Integer enable
disable (default)
RW supermode
Name Type Value Access CLI Parameter
Operating Frequency
Channel
Integer Varies by regulatory domain and
country. See Available Channels
RW channel
Supported Data Rates Octet String See Transmit Rate, below R suppdatarates
Transmit Rate Integer32 0 (Auto Fallback)
6 Mbits/sec
9 Mbits/sec
12 Mbits/sec
18 Mbits/sec
24 Mbits/sec
36 Mbits/sec
48 Mbits/sec
54 Mbits/sec
RW txrate
Physical Layer Type Integer ofdm (orthogonal frequency division
multiplexing)
Rphytype