User Manual

Command Line Interface (CLI) AP-4000/4000M/4900M User Guide
Parameter Tables
221
* Higher roaming threshold value creates a more static Mesh environment. Lower roaming threshold value creates a more dynamic Mesh
environment.
† A QoS profile corresponding to this index number must exist.
‡ This command resets the following parameters to their default values: Maximum Active Mesh Links, Maximum Hops to Portal, Hop Factor,
RSSI Factor, Medium Occupancy Factor, Receive Signal Strength Cut-off, and Roaming Threshold.
Medium Occupancy
Factor
Integer32 0–10 RW meshmedocfactor
Signal Strength Cutoff Integer32 0–26 RW meshsignalstrengthcutoff
Max Hops to Portal Integer32 1–4 RW meshmaxhops
Mesh Mobility Mode
(Mesh AP only)
Integer 1 (static)
2 (roaming)
RW meshmobility
Reset Mesh Parameters
to Defaults
‡
Integer32 1 or 2 RW meshadvresettodefault
Mesh QoS Profile Integer32 1–10
†
RW meshqosprofile
Mesh Link Only (no client
access on Mesh radio)
Integer 1 (enable)
2 (disable)
RW meshlinkonly
Mesh Auto Switch Mode
(Mesh Portal only)
Integer 1 (enable)
2 (disable)
RW meshautoswitchmode
Current Mesh Mode Integer 1 (Disabled) (default)
2 (Mesh Portal)
3 (Mesh AP)
R meshcurrentmode
Name Type Value Access CLI Parameter