User Manual

Installation and Initialization AP-4000/4000M/4900M User Guide

Hardware Installation

• Use a cross-over Ethernet cable or adapter if you intend to connect the unit to a single computer.

Figure 2-4 Cabling without PoE

3. Optionally, connect an RS-232 cable (not shown) to the RS-232 console port (the right port, labeled “RS-232”).

NOTE: You cannot install the security cover to the AP-4000/4000M/4900M if an RS-232 cable is connected.

4. Continue with Install the Security Cover (Optional).

Cabling with Power Over Ethernet (PoE)

1. To use PoE, you must use a PoE adapter such as the ORiNOCO 1-Port Active Ethernet DC Injector (ordered

separately). Connect one end of an Ethernet cable (not supplied) to the unit’s LAN port. Connect the other end to the

Data and Power Out port of the DC Injector (see figure).

2. Connect one end of a second Ethernet cable (not supplied) to the Data In port of the DC Injector (see figure). The

other end of the cable should not be connected to another device until after installation is complete:

• Use a straight-through Ethernet cable if you intend to connect the unit to a switch, hub, or patch panel.

• Use a cross-over Ethernet cable or adapter if you intend to connect the unit to a single computer.

Figure 2-5 Cabling with PoE

3. Optionally, connect an RS-232 cable (not shown) to the RS-232 console port (the right port, labeled “RS-232”).

NOTE: You cannot install the security cover to the AP-4000/4000M/4900M if an RS-232 cable is connected.

4. Continue with Install the Security Cover (Optional) below.