User's Manual

Bootloader CLI and ScanTool

Bootloader CLI

The Bootloader CLI is a minimal subset of the normal CLI used to perform initial configuration of the device. The Bootloader CLI is

available when the device embedded software is not running.

This interface is only accessible through the serial interface, if:

• The device does not contain a software image

• An existing image is corrupted

• An automatic (default) download of image over TFTP has failed

The Bootloader CLI provides the ability to configure the initial setup parameters; and depending on this configuration, a

software file is downloaded to the device during startup.

The Bootloader CLI supports the following commands:

• factory_reset: Restore the factory settings

• help: Print Online Help

• reboot: Reboot the device

• set: Set the parameters

• show: Show the parameters

The Bootloader CLI supports the following parameters (for viewing and modifying):

• ipaddr: IP Address

• systemname: System Name

• gatewayip: Gateway IP Address

• serverip: Server IP Address

• ipaddrtype: IP Address Type

• netmask: Net Mask

• filename: Image file name (including the file extension)

If the Bootloader fails to load the firmware from flash, it tries to get the firmware from the network. While trying to get

firmware from the network, the device should be powered on using Ethernet 1 interface of the device. The default

configuration of the Bootloader parameters are as follows:

Parameter Value

ipaddr 169.254.128.132

netmask 255.255.255.0

gatewayip 169.254.128.132

systemname systemname

serverip 169.254.128.133

filename imagename

ipaddrtype dynamic

Tsunami® 8100 Series - Software Management Guide 235