Manualshelf

User's Manual

ManualsBrandsProxim Wireless ManualsElectronicsTsunami 8000 Point-to-Point and Point-to-multipoint Product
31323334353637383940
Advanced Configuration
5.2.3 IP Configuration (Routing Mode with PPPoE Client Enabled)
: IP Configuration in Routing mode with PPPoE client enabled is applicable only in SU mode. See PPPoE End Point
(SU Only)
To configure the IP parameters of the device when configured in Routing mode with PPPoE client enabled, navigate to
ADVANCED CONFIGURATION > Network. The IP Configuration screen appears:
Figure 5-6 IP Configuration (Routing Mode with PPPoE Client Enabled)
Tabulated below is the table which explains the method to configure IP parameters in Routing mode with PPPoE client
enabled:
Parameter Description
Ethernet
Please note that the number of Ethernet interfaces depend on your device.
IP Address Represents the IP address of the Ethernet interface.
By default, the static IP address for Ethernet1 is set to 169.254.128.132 and
169.254.129.132 for Ethernet2. You can manually change the IP address.
Subnet Mask Represents the subnet mask of the Ethernet interface.
By default, the static subnet mask is set to 255.255.255.0. You can manually change the
subnet mask.
Tsunami® 8100 Series - Software Management Guide 40