Software Guide

Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide 119
·
The roaming time for an SU increases when the RADIUS based authentication is enabled on the BSU.
·
When an SU registers with a new BSU, it will transfer all the data, buffered during transition, to the new BSU.
5.4.6 BSU / SU Profiles
In the BSU / SU Profiles tab, you can explicitly map a link profile to the peer device (See
H   I B   |    
). When a link is
established, using the peer MAC address, it is associated with a link profile based on the mapping created here. When no
explicit mapping is created then the link is associated with the default profile.
5.4.6.1 Add a Profile
: In this section, we have explained the method to map a link profile to an SU. The same method should be followed to
map a link profile to a BSU.
To map a link profile to an SU device, navigate to ADVANCED CONFIGURATION > Wireless > Interface 1 > SU Profiles.
The SU Profiles screen appears:
Figure 5-43 SU Profiles
Click Add in the SU Profiles screen. The SU Profile Add Entry screen appears:
Figure 5-44 Add an SU Profile Entry
Configure the following parameters:
·
SU Wireless MAC Address: Type the MAC Address of the peer.
·
Device Name: Type the name of the peer.
·
Link Profile Name: Map a link profile to the peer from the list of Link Profiles.
After configuring the required parameters, click ADD and then COMMIT.
The profile is mapped to the peer device and is listed in the SU Profiles screen.