Software Guide

Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide 124
After configuring the required parameters, click Add and then COMMIT.
Encryption Type Select encryption type as either None, WEP, TKIP or AES-CCM.
1. None - If the encryption type is selected as None, then there exist no security to the
data frames transmitted over the wireless medium.
2. WEP (Wired Equivalent Privacy) - Represents the WEP Encryption type, which
uses RC4 stream cipher for confidentiality and CRC-32 for integrity. The supported
key lengths for WEP are 5/13/16 ASCII characters or 10/26/32 Hexadecimal digits.
– Key1 / Key 2 / Key 3 / key 4: You can configure a maximum of four WEP keys.
Enter 5/13/16 ASCII Characters or 10/26/32 Hexadecimal digits for WEP keys.
– Transmit Key: Select one out of the four keys described above as the default
transmit key, which is used for encrypting and transmitting the data.
3. TKIP - Represents the TKIP Encryption type, which uses RC4 stream cipher for
confidentiality. TKIP provides per-packet key mixing, a message integrity check and a
re-keying mechanism. It uses 128-bit keys for encryption. The key length for TKIP is
16 ASCII characters or 32 Hexadecimal digits.
– Key1 / Key 2 / Key 3 / key 4: You can configure a maximum of four TKIP keys.
Enter 16 ASCII characters or 32 Hexadecimal digits.
– Transmit Key: Select one out of the four keys described above as the default
transmit key, which is used for encrypting and transmitting the data.
4. AES-CCM - Represents CCM Protocol with AES Cipher restricted to 128 bits.
·
Key: Enter 16 ASCII characters or 32 Hex Digits for AES-CCM encryption keys.
Entry status Enables you to either Enable or Disable the security profile on the device. By default, it is
enabled.
Network Secret Enter the WORP Protocol Secret Key, ranging from 6 to 32 characters, used for
authenticating an SU with a BSU, and an End Point B with End Point A. The network secret
should be same for both BSU and SU. Similarly, the network secret should be same for an
End Point A and an End Point B.
:
·
You can create a maximum of eight security profiles.
·
A QuickBridge supports AES-CCM encryption type only.
·
Special characters like - = \ " ' ? / space are not allowed while configuring the keys.
·
All four Keys (Key1, Key2, Key3, Key4) must be of same length and same type, that is, all four Keys must
be either ASCII characters or Hexadecimal digits.
·
Transmit Key can be any one of the four keys, provided all the four keys are same in an SU and BSU, or
End Point devices.
·
WEP and TKIP Encryption types are supported only in legacy modes.
·
The encryption mode should not be selected as AES-CCM while the device is interoperating with legacy
Tsunami
®
MP.11 family devices.
Parameter Description