Manualshelf

Software Guide

ManualsBrandsProxim Wireless ManualsElectronics802.11 a/b/g/n Mini-PCI module
131132133134135136137138139140
Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide 136
Figure 5-58 QoS PIR MAC Address Add Entry
c. Provide the MAC Address, Mask, Comment, Entry Status details and click Add. Comment field can be used to identify
when this particular entry is referred in PIR Rule/QoS Class.
The bit that is enabled in the “MAC Mask” configuration, the corresponding bit’s value in the “MAC Address” configuration
should match with the same bit of the incoming traffic’s MAC Address (other bits of the incoming traffic are ignored). Then it
is considered as matching traffic and the rest are unmatched traffic. The following is explained with the help of an example:
1. Creating Matching profile for single MAC address
To apply QoS classification for traffic which is originated / destined from / to a Device only.
MAC Address: 00:20:A6:00:00:01
MAC Mask: FF:FF:FF:FF:FF:FF
In this example, all bits in the MAC Mask are enabled, so incoming traffic’s MAC address should exactly match with
specified configured MAC Address (that is, 00:20:A6:00:00:01). Other traffics are considered as non-matching traffic.
2. Creating Matching profile for all MAC Address
MAC Address: 00:00:00:00:00:00
MAC Mask: 00:00:00:00:00:00
In this example, all bits in the MAC Mask are disabled, so any traffic is considered as matching traffic.
3. Creating Matching Profile for Broadcast MAC Address
MAC Address: FF:FF:FF:FF:FF:FF
MAC Mask: FF:FF:FF:FF:FF:FF
4. Creating Matching Profile for all Multicast MAC Address
MAC Address: 01:00:00:00:00:00
MAC Mask: 01:00:00:00:00:00
5. Creating Matching Profile for range of MAC Address (00:20:A6:00:00:01 to 00:20:A6:00:00:FF)
MAC Address: 00:20:A6:00:00:00
MAC Mask: FF:FF:FF:FF:FF:00
5.6.2.0.2 QoS PIR IP Address Configuration
1. Navigate to ADVANCED CONFIGURATION > QoS > PIR List > IP Address Entries, the QoS PIR IP Address Entries
screen appears. A single predefined IP Address entry is displayed. You can configure a maximum of 256 entries. IP
Address, Subnet Mask combination should be unique. This IP Address entry can be referred in the PIR Rule’s Source or
Destination IP Address Classification. IP Address Entry referred by any PIR rule cannot be deleted.
2. Click OK.