Software Guide

Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide 146
5.6.2.1.5.2 Adding Destination IP Address
a. Navigate to ADVANCED CONFIGURATION > QoS > PIR List. Click Details. The QoS PIR Edit Entry screen
appears.
b. Navigate to Destination IP Address Entries tab and then click Add to add a new entry. The following screen
appears.
Figure 5-71 QoS PIR Destination IP Address Add Entry
c. All the entries present in the PIR IP Address Entries are displayed in the IP Address Entry Table. Select the
appropriate radio button and click Add. After adding the entry for this specific PIR, it is displayed in the Existing IP
Address Entries table. For deleting an entry, click Delete for the corresponding entry in the PIR Details page.
The following is explained with the help of an example:
1. Creating Matching profile for single IP address
To apply QoS classification for traffic which is originated / destined from / to a Device only.
IP Address: 169.254.28.133
IP Mask: 255.255.255.255
In this example, all bits in the IP Mask are enabled, so incoming traffic’s IP address should exactly match with specified
configured IP Address (i.e, 169.254.28.133). Other traffic is considered as non-matching traffic.
2. Creating Matching profile for all IP Address
IP Address: 0.0.0.0
IP Mask: 0.0.0.0
In this example, all bits in the IP Mask are disabled, so any traffic is considered as matching traffic.
3. Creating Matching Profile for range of IP Address (169.254.128.0 to 169.254.128.255)
IP Address: 169.254.128.0
IP Mask: 255.255.255.0
4. Creating Matching Profile for Broadcast IP Address
IP Address: 255.255.255.255
IP Mask: 255.255.255.255
5. Creating Matching Profile for Single Multicast IP Address
IP Address: 224.0.0.9
IP Mask: 255.255.255.255