Software Guide

Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide 161
: When Double VLAN is enabled on the device, the Service VLAN ID should not be set to -1.
7. Service VLAN Priority: This parameter is used to set IEEE 802.1p priority in outer/service VLAN tag for the data
frames. By default, the priority is set to 0. To set the VLAN priority, enter a value ranging from 0 to 7.
5.8.2 Ethernet VLAN Configuration
You can configure VLAN on the Ethernet interface(s) by using any one of the following VLAN Modes:
1. Transparent Mode
2. Access Mode
3. Trunk Mode
5.8.2.1 Transparent Mode
Transparent mode can be configured in a BSU, SU and End Point devices. This mode is equivalent to NO VLAN support and is
the default mode. It is used to connect VLAN aware or unaware networks. In this mode, the device transfers both tagged and
untagged frames received on the Ethernet or WORP interface.
To configure the Ethernet interface of the device in VLAN Transparent Mode, navigate to ADVANCED CONFIGURATION >
VLAN > Ethernet. The VLAN Ethernet Configuration screen appears:
Figure 5-87 Transparent Mode
Given below is the table which explains the method to configure the device in Transparent mode:
Click OK and then COMMIT.
Parameters Description
Interface Displays the name of the Ethernet interface.
VLAN Mode Select the VLAN mode as Transparent.
: When the device is configured in Double VLAN mode, do not configure the
Ethernet interface of the device in Transparent Mode.