Software Guide

Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide 168
·
An MP.11 SU should locally configure VLAN parameters when connected to a MP 82x/8000 BSU in legacy mode as
the BSU will not assign any VLAN parameters based on RADIUS authentication.
·
An MP 82x/8000 SU should locally configure VLAN in legacy mode when connected to a MP.11 BSU, should locally
configure VLAN parameters as the BSU shall not assign VLAN parameters based on RADIUS authentication.
5.10 Filtering (Bridge Only)
Filtering is useful in controlling the amount of traffic exchanged between the wired and wireless networks. By using filtering
methods, we can restrict any unauthorized packets from accessing the network. Filtering is available only in bridge mode.
The various filtering mechanisms supported by the device are as follows:
·
B             
·
  k    C }

} { {          
·
} { y k    {         
·


B   x B B         
·
    

       {      
·


 B v    k

       I   
Filters get activated only when they are globally enabled on the device. To apply/configure global filters on the device,
navigate to ADVANCED CONFIGURATION > Filtering. The Filtering screen appears.
Figure 5-93 Filtering
Given below is the table which explains Filtering parameters and the method to configure the configurable parameter(s):
Parameter Description
Global Filter Flag By default, Global Filtering is disabled meaning which no filters are applied on the device.
To apply filters on the device, enable the Global Filter Flag.
Please note that if Global Filter Flag is not enabled on the device, then none of the filters
can be applied on the device.