Software Guide
Basic Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide 44
Frequency Domain This parameter specifies the country of operation, permitted frequency bands and
regulatory rules for a particular country or domain. When the frequency domain is
selected, the Dynamic Frequency Selection (DFS) and Automatic Transmit Power Control
(ATPC) features are enabled automatically if the selected country and band has a
regulatory domain that requires it. The Frequency domain selection pre-selects and
displays only the allowed frequencies for the selected country or domain.
:
·
Devices are pre-configured to scan and display only the outdoor frequencies
permitted in the respective country. No other countries, channels, or frequencies
can be configured.
— Do not exceed the maximum EIRP permitted in the particular country.
— Configure the ATPC/TPC parameters by choosing the correct cable type /
attenuator
— It is the responsibility of the professional installer to properly install and
configure the device parameters in accordance with the respective
country laws.
For non-US device, the default frequency domain selected is World 5MHz. For more
details on frequency domains, see
j x k k {
k
.
Radio Mode Represents the radio mode of the device. Based on the SKU, the radio mode is set to either
BSU, SU, End Point A or End Point B.
In a BSU device, the radio mode can be changed from BSU to SU and vice versa. Also, in an
End Point A device, the radio mode can be changed from End Point A to End Point B and
vice versa.
: A change in radio mode will reset wireless and WORP parameters to defaults
after reboot.
Channel Bandwidth Represents the width of the frequency band that is used to transmit data on the wireless
interface. By default, it is set to 20 MHz. 40 MHz can be selected for higher throughputs
depending on the distance and signal quality. 5 and 10 MHz can be selected for greater
flexibility in spectrum selection.
: The 40 MHz frequency band is not applicable to MP 800 & 8000 BSU and SU
devices, when configured in
H k j C {
.
For more details on supported Channel Bandwidth, see
j x k k {
k
.
Parameter Description