Software Guide

Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide 70
·
Echo Interval and Echo Failure to detect server unavailability
·
MPPE with stateful and stateless mode aligned with 40/56/128 bit encryption
To configure PPPoE feature,
1. Navigate to ADVANCED CONFIGURATION > Network > PPPoE > PPPoE Client. The following PPPoE Client
screen appears:
Figure 5-17 PPPoE Client Status
2. By default, the PPPoE feature is disabled on the client. To enable, select Enable from Status drop-down box.
3. Next, click OK. Please note that a change in the PPPoE client status requires you to reboot the device.
4. On enabling the PPPoE client feature, the following screen appears:
Figure 5-18 PPPoE Client Configuration