Software Guide

Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide 80
After configuring the required parameters, click OK and then COMMIT.
Reboot the device, if you have changed the Admin Status configuration.
5.3.2 Advanced Configuration
The Advanced Configuration feature enables you to achieve high availability and link aggregation in a wireless medium by
using two or more parallel links and additional Link Aggregation Control Protocol (LACP) capable switches.
To view and perform advanced Ethernet configuration, click Advanced in the Ethernet Interface Properties screen. The
following screen appears:
Operational Tx Mode Displays the current operational transmission mode of the Ethernet interface. It supports
two types of transmission modes:
·
Half Duplex: Allows one-way data transmission at a time.
·
Full Duplex: Allows two-way transmission simultaneously.
Speed And TxMode Enables the user to select the speed and transmission mode of the Ethernet interface. By
default, it is set to Auto. When set to Auto (recommended to set), both the transmitter
and the receiver negotiate and derive at the best transmission mode.
:
·
Please ensure the same transmission modes are configured on the transmitter
and the receiver device.
·
In case of 82x devices, the Auto option will support Gigabit if the other end is
capable of supporting it.
Admin Status This parameter is applicable only when the device support more than one Ethernet
interface. By default, both the Ethernet interfaces of the device are enabled. The first
Ethernet interface is always enabled; whereas the second Ethernet interface can be either
enabled or disabled as desired.
Parameter Description
: Applicable only to QB-8100-EPA/LNK, QB-8150-EPR/LNK, QB-8150-LNK-100, QB-8151-EPR/LNK,
QB-8200-EPA/LNK, and QB-8250-EPR/LNK.