Software Guide

Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide 83
The default profile can be modified to suit the network requirements. However, it is possible that one profile may not be able
to satisfy the requirements of all the WORP links (due to different operating conditions, link distance etc). In such a case,
additional link profiles can be defined and associated with respective links appropriately (refer
      B   |    
on how to
associate profile to a link).
It is intended that all the WORP links that are expected to exhibit similar behavior be grouped under one link profile.
:
·
You can edit but not delete the Default profile.
·
The link profiles in use cannot be deleted; This includes the Roaming Link Profile irrespective of the roaming
status.
·
A single profile can be mapped to multiple SUs/BSUs.
·
Link profiles are local to the device and should be configured independently on all devices.
5.4.1.1 Add a Link Profile
To add a link profile, click Add in the Link Profiles screen. The Link Profile Add Entry screen appears:
Figure 5-27 Add a Link Profile
Type a name for the link profile in the Profile Name field. Next, click ADD and then COMMIT.
:
·
By default, the link profiles are created with default values.
·
After adding a link profile it must be associated with a peer (refer
      B   |    
for it to be effective.
5.4.1.2 Edit a Link Profile
The link profiles are created with pre-configured wireless parameters.
In order to edit these pre-configured values for a desired profile, click Edit symbol in the Link Profiles screen. The Link
Profile Edit Entry screen appears, which is classified under two categories: Basic and Advanced.