User's Manual

Technical Specifications
Tsunami
®
800 and 8000 Series - Hardware Installation Guide 132
Power Supply
Products Category Specification
MP-8100-BSU
MP-8100-SUA
MP-8150-SUR
MP-8150-SUR-100
MP-8200-BSU
MP-8250-BS9
MP-8250-BS1
MP-8200-SUA
MP-8250-SUR
QB-8100-EPA/LNK
QB-8150-EPR/LNK
QB-8150-LNK-100
QB-8151-EPR/LNK
QB-8200-EPA/LNK
QB-8250-EPR/LNK
Input Voltage

Via RJ-45 Ethernet interface supplying 48 VDC and 0.67A on Ethernet Port#1

12 V-DC through RJ-11 serial port (for diagnostic purpose)
: Only one of the above input voltage options should be used at a time, to
power on the device. Combination of any two options, may damage the
device.
Tabulated below are the power consumption details.
Output Voltage* 48VDC through Ethernet Port #2. Power Always ON.
: Output voltage of 48VDC requires a 60-80W high power POE, available
with Proxim Wireless Corporation on request.
Power over
Ethernet Injector
y
Input: 100 – 250 V-AC (47 – 63 Hz)
y
Output: 48 V-DC at 0.67 A (32 Watts)
y
Pin-out: +48 V on pins 4/5, -48 V on pins 7/8
y
Size: 5.24x2.13x1.42 inches(133x54x36 mm)
y
Weight: 7 ounces (200 g)
y
Temp: 0 to 40º C
z { | } ~                                                                                  
Products Typical
Consumption
Consumption (With
Heaters ON)
MP-8100-BSU
MP-8100-SUA
MP-8150-SUR
MP-8150-SUR-100
QB-8100-EPA/LNK
QB-8150-EPR/LNK
QB-8150-LNK-100
QB-8151-EPR/LNK
QB-8250-EPR/LNK
6 Watts 17 Watts maximum, with
two heaters ON
MP-8200-BSU
MP-8250-BS9
MP-8250-BS1
MP-8200-SUA
MP-8250-SUR
QB-8200-EPA/LNK
QB-8250-EPR/LNK
12 Watts 22 Watts maximum, with
two heaters ON