User's Manual

8000 Series - Hardware Overview and Installation
Tsunami
®
800 and 8000 Series - Hardware Installation Guide 80
Figure 3-32 Grounding the Device
Step 10: Power ON the Device
Plug in the power cord into a power outlet after connecting the PoE Injector to the device by using Cat5/Cat5e or better
cable. There is no ON/OFF switch on the device. To disconnect power, unplug the RJ45 connector from the LAN+DC port on
the PoE Injector.
Step 11: View LEDs
When the device is powered on, it performs startup diagnostics. When startup is complete, the LEDs show the device’s
operational state. The LEDs are available at the device Ethernet connector inside the enclosure. You can see the LEDs through
the ethernet connector.
The LEDs will not be visible if the RJ45 connector is weatherproofed.
Figure 3-33 LEDs
The following table states the status of LEDs and the corresponding operational state of the device:
LED State Ethernet interface
Power/Ethernet LED Wireless LED
Off No Power Radio is not present or failed to detect
Amber No Application Image detected (In
Bootloader CLI / ScanTool mode)
Power is ON and device detects Reload
signal
Blinking Green Power is ON and the Ethernet link is down Radio is detected but wireless link has
not been established yet
Solid Green Power is ON and the Ethernet link is up. Radio is detected and wireless link has
been established