User's Manual Part 2

CLI for Mesh and Access Point Module MeshMAX 5054 Series User Guide
User Guide
295
Inventory Management Information
The inventory management commands display advanced information about the AP’s installed components. You may be
asked to report this information to a representative if you contact customer support.
Network Parameters
IP Configuration Parameters
NOTE: The IP Address Assignment Type (ipaddrtype) must be set to static before the IP Address (ipaddr), IP Mask
(ipmask) or Default Gateway IP Address (ipgw) values can be entered.
Name Type Value Access CLI Parameter
System Inventory
Management
Subgroup N/A R sysinvmgmt
Component Table Subgroup N/A R sysinvmgmtcmptbl
Component Interface
Table
Subgroup N/A R sysinvmgmtcmpiftbl
Name Type Value Access CLI Parameter
Network Group N/A R network
IP Configuration Group N/A R ip (Note: The network and
ip parameters display the
same information)
IP Address IpAddress User Defined RW ipaddr
IP Mask IpAddress User Defined RW ipmask
Default Router IP
Address
IpAddress User Defined RW ipgw
Default TTL Integer User Defined (seconds)
0 - 255, 64 (default)
RW ipttl
Address Type Integer static
dynamic (default)
RW ipaddrtype